Caple C813C Bedienungsanleitung

AO1X ARM POS MAINTENANCE MANUAL Pinnacle Technology Corp. Address: North 4th Floor, Guangxia Building, Torch High-Tech

7 3. Turn the mainboard rightward. 4. Pull out the connection cable of the mainboard and touch panel circled on the left picture.

8 2. Install the connection cable between the mainboard and the touch panel. 3. Install the mainboard to the pressing block as arrow 1 shows f

9 Note: The mainboard should be inserted into the gap of the pressing blocks. 4. Use two screws circled as the left pictur

10 3.5. Touch Panel Module Disassembly 1. Unscrew the 6 screws circled on the left picture and take out their pedesta

11 Note: Please install the four pedestals with tweezers first, and then install the screws to fix the printer module. 3.8. SIM

12 3.10. Thermal Printer Disassembly 1. Unscrew the screw circled as the left picture. 2. Take away the fixing frame.

13 3.12. RFID Module Disassembly Take out the RFID module as the arrow shows. 3.13. Communication Board Disassembly 1. Unscrew the

14 4. Take away the two pieces of communication baffle. 5. Pull up the lock that circled as the left picture and take away the FFC cable. 6.

15 3.14. Battery Disassembly 1. Rip off the tape on the battery. 2. Pull out the connection cable between the battery and the p

16 3.16. Buzzer Disassembly Use alcohol to dissolve the cement and then take away the buzzer. 3.17. Ibutton Disassembly Unscrew th

17 （3） If the power indicator is on but the machine cannot work, it may be the damage of mainboard software or mainboard hardware. Please update the s

18 Click “new session” button, then lick “connect” Choose “Serial”, then click “Next” Cancel Next Fini

19 Before Choose baud rate “115200”, then click “Next” Next Before Cancel Click “Finish” Cancel Fini

20

21 the screen becomes dark, the CR shows data below.

22 means the updating process begins. After finishing the updating, the screen shows words “upgrade success”, as the picture below.

23

24 4.2. AO1X Terminal Automatically Restart (or Power off) Causal analysis and resolution: If the AO1X is frequently power off or startup automatical

25 printing paper. Or it may be the dirt in the thermal printer, please clean the thermal printer by a piece of cotton with alcohol. (2) Print abnorma

26 for testing again. 4.9. PS2 Scanner cannot Scan Causal analysis and resolution: （1） Check the status of scanner ; （2） Check if PS2 connector

Contents 1. PREPARATION ...

27 （1） Check if the connector of drawer fits the definition of SENOR standard drawer connector; （2） Check if the 6pin crystal connector becomes oxid

1 1. PREPARATION There are some necessary tools for servicing cash register, you must prepare them before servicing, so as to ensure the good quality

2 3. DEMOUNTING AND ASSEMBLING PROCESS Note: This chapter will describe the demounting process in detail and give installation notices for parts of mo

3 Unscrew the 2 screws. Prize up one corner of the window plate with knife blade as the left picture

4 1. Lift up the back crust a little (about 1cm) towards the direction as the arrow shows on PIC①. 2. Push the back curst a l

5 3. Open the crust. 4. Take off the cables that circled on the left picture from the front crust. Note: When ope

6 3.3. Mainboard Disassembly 1. Pull up the cables that circled on the left picture from the main board. 2. Unscrew the 2 screws