Caple CR9215 Technical Information PDF herunterladen (Seite 21)

All tests are to be conducted under the rules in force

following best practice procedures. In the UK these are

the procedures laid down by CORGI and the Gas Safety

and use Regulations.

1. ELECTRICAL TESTS

Electrical warning

THIS APPLIANCE IS SUPPLIED IN COMPONENT AND

SUB- ASSEMBLY FORM. WHILST THE SUB-ASSEMBLIES

THEMSELVES HAVE BEEN TESTED FOR ELECTRICAL

SAFETY AT REDFYRE, IT IS ESSENTIAL THAT THE WHOLE

APPLIANCE IS TESTED WHEN IT IS FULLY ASSEMBLED.

THIS WORK CAN ONLY BE UNDERTAKEN BY A

SUITABLY QUALIFIED ELECTRICIAN TRAINED IN THE

USE OF SPECIALISED EQUIPMENT. THE TEST MUST

INCLUDE;

• EARTHBONDCONTINUITY

• INSULATIONRESISTANCECHECK

• ELECTRICALINSULATIONFLASHTEST

IMPORTANT

IF THERE IS NO MAINS SUPPLY OR THE ABOVE TESTS

CANNOT BE CARRIED OUT, ENSURE THAT A WARNING

LABEL IS ATTACHED TO THE APPLIANCE STATING

THAT IT SHOULD NOT BE USED UNTIL ELECTRICALLY

TESTED BY A SUITABLY QUALIFIED ELECTRICIAN AND

INFORM THE CUSTOMER.

2. PRESSURE TEST

 • Purgethegassupplytoexpelanydebristhatmayblock

the gas control.

 • Connectasuitablepressuregaugetotheinletpressure

test point located on the isolation device and turn the gas

supply on. Light the burner and check all gas joints for

possible leaks. Turn the burner onto maximum and check

that the supply pressure is as stated on the data badge. Turn

the gas off and replace the test point screw.

 • Checkthesepressuresareunaffectedbyothergas

appliances being used on the property.

 • Checkthepressuretestpointforleaks.

3. SPILLAGE CHECK

 • Closealldoorsandwindowsintheroom.Lightthe

burner and operate on maximum for 5 minutes.

 • Positionalightedsmokematchjustinsidethedraught

divert hood to ensure all smoke is drawn in. If in doubt, run

the burner for a further 10 minutes and repeat the test.

 • Repeatthetestwithanyextractorfansrunningon

maximum in the room or adjacent rooms and keep

interconnecting doors open.

IF SPILLAGE PERSISTS, DISCONNECT THE COOKER AND

SEEK EXPERT ADVICE.

4. GAS RATE

 • Checkthegasrate(naturalgasmodelsonly).

5. FUNCTIONAL CHECK

5.1 Check the general function of the cooker:

– Ignition

– Cross lighting

– Valve operation

– Thermostat operation

– Flame failure device

NOTE: THE COOKER WILL TAKE SEVERAL HOURS TO

REACH FULL OPERATING TEMPERATURE. FURTHER

ADJUSTMENT OF THE THERMOSTATIC GAS CONTROL

MAY BE REQUIRED TO SET THE OVEN TO THE DESIRED

OPERATING TEMPERATURE.

INSTALLATION INSTRUCTIONS

COMMISSIONING

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

Caple CR9215 Technical Information Seite 21

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kochfelder Caple CR9215