Caple C602E Installationshandbuch PDF herunterladen (Seite 24)

Revision 1.9 - 24 -

Electrical Installation

When performing electrical installation, be certain to install and secure everything in a way where it is not

subject to damage from moving parts, sharp edges, exhaust systems, etc.

• Any deviation from PALFINGER Liftgates’s recommended power setup (see 6 Electrical

Installation) will void warranty and product liability unless you have a written confirmation by

PALFINGER Liftgates that allows you to do specific changes.

• Never exceed rating of existing fuses located at the battery, control board and/or the pump and

motor which may result in serious damage to the equipment.

• Never jump the 150 Amp circuit breaker at the batteries unless otherwise instructed by the

PALFINGER Liftgates technical support center

• Assure all connections are tight and securely fastened

• Heat shrink any connection to all cables.

• Never secure a cable in a way where it can make contact with other wiring, brake-, fuel- or air-

lines etc. or get pinched against other objects.

6.1

Breaker Installation

• Mount circuit breaker securely in battery box or at positive battery post using supplied buss bar

• Connect liftgate 2Ga. cable to open stud on circuit breaker

• Connect 2Ga. jumper from open stud on breaker to positive battery post if circuit breaker was not

mounted straight at battery

150 AMP

Resetable Breaker

Figure 19 Circuit breaker installation

Connect 2 Ga cable

com

from lift gate

Connect here

to Positive

Battery post

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 39 40

Keine Kommentare

Caple C602E Installationshandbuch Seite 24