Caple C702G Wartungshandbuch PDF herunterladen (Seite 32)

5-3

User MODE: Auto EMF function is on.(LED is green)

Auto EMF function on -> off

a. Open the MENU (U),TAG7)-

”

DISPLAY MODE

”

, and Press

“

”

and

“

▲

”

switch at once.

b. Then

“

DEGAUSS OK

”

appear on OSM, and AUTO EMF function is

on state.

When push any switch and power on/off, AUTO EMF function become

off state.

But when receive frequency change, AUTO EMF function stay on state.

5) After sufficiently degaussing the CRT, move degaussing coil slowly away from the panel surface while

rotating from corner to center, taking more than 3 seconds.

Turn off SW more than 1 m away from the CRT. Degauss again if the unit is gassed.

6) When aperture grille get entangled while degaussing, receive the signal of 1dot alternate pattern and

degauss again. If aperture grille remain entangled, Put vibrate from side.

5. Signal Generator

LVG-1603 is recommended for signal generator.

Use calibrated signal generators. However, use VG-819 in focus regulation.

Note) Adjustment timings are timing tables and are not programmed timing.

6. Color Analyzer, Convergence Meter, Landing Mater

The color analyzer should be CA-100 (made by MINOLTA) or compatible.

The convergence meter should be CC-100 (made by MINOLTA) or compatible.

The Landing meter should be KLD-01 (made by KAMAYA) or compatible.

Over 1m

SW OFF

Magnetized Pattern Example

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 285 286

Keine Kommentare

Caple C702G Wartungshandbuch Seite 32