Caple C813C Bedienungsanleitung PDF herunterladen (Seite 5)

ASSEMBLY INSTRUCTION

Tools Required to Assemble the Machine: Two Adjustable Wrenches and Allen Wrenches

NOTE: It is strongly recommended this machine be assembled by two or more people to

avoid possible injury.

STEP 1 (See Diagram 1)

A.) Attach the Rear Stabilizer (#2) to the back of the Base Frame (#1). Then attach the Rear

Vertical Beam (#4) to the back of the Rear Stabilizer (#2). Align the holes and secure it with

two M10 x 3 ¾” Carriage Bolts (#92), ∅ ¾” Washers (#114), and M10 Aircraft Nuts (#112).

DO NOT tighten all the nuts and bolts yet.

B.) Attach the Front Vertical Beam (#3) to the Base Frame (#1). Secure it with two M10 x 3 ¾”

Carriage Bolts (#92), ∅ ¾” Washers (#114), and M10 Aircraft Nuts (#112).

C.) Attach the Upper Frame (#10) to the top of the Vertical Beam (#3) & (#4). Secure the front with

two M10 x 2 3/8” Carriage Bolts (#94), one 4 5/8” x 3” Bracket (#54), two ∅ ¾” Washers

(#114), and two M10 Aircraft Nuts (#112). Secure the back with a M10 x 2” Allen Bolt (#98),∅

¾” Washer (#114) and 3 1/8” x 3” Bracket (#52) to the top hole. Use one M10x2 3/8” Carriage

Bolt (#94), ∅ ¾” Washer (#114) and M10 Aircraft Nut (#112) to secure the bottom hole.

D.) Attach the Lat Bar Holder (#21) to Upper Frame (#10). Secure it with a M10 x 3 ¾” Carriage

Bolt (#92), ∅ ¾” Washer (#114) and M10 Aircraft Nut (#112).

DIAGRAM 1

1 2 3 4 5 6 7 8 9 10 ... 21 22

Keine Kommentare

Caple C813C Bedienungsanleitung Seite 5