Caple C871i Bedienungsanleitung PDF herunterladen (Seite 185)

Apple II Computer Info

#############################################################################

### FILE : gsfans

#############################################################################

### Created : Thursday, September 18, 1997 Modified: Thursday, September 18,

1997

### File Type: "TEXT" File Creator: "LMAN"

### File Size: 2000 bytes 1 KB

#############################################################################

Path:

news1.icaen!news.uiowa.edu!uunet!in5.uu.net!newsflash.concordia.ca!newsflash.conco

rdia.ca!not-for-mail

From: [email protected] (Mitchell Spector)

Newsgroups: comp.sys.apple2

Subject: Re: IIgs internal fan hookup question...

Date: 18 Sep 1997 03:03 -0500

Organization: Concordia University

Lines: 30

Distribution: world

Message-ID: <[email protected]>

References: <[email protected]>

NNTP-Posting-Host: vax2.concordia.ca

NNTP-Posting-User: SPEC

News-Software: VAX/VMS VNEWS 1.50AXP

In article [email protected] (Perry Dueck) writes...

>If one were to install an internal fan in an Apple IIgs, what is the

>proper Amps level that the fan should be rated at, in order to connect it

>to the two pin fan connector at the rear of the IIgs motherboard?

The pinout for the "Fan" connector is +12V and Ground. The +12 is

the pin closest to the powersupply, or the pin on the left if you are

facing the GS motherboard from the front end. Most fan wires are color

coded, so the red wire goes to power and black to ground.

>I pulled a perfectly good working fan out of a non-functioning 386sx power

>supply. This fan I have is an NMB "FLOW MAX", and it is rated:

>DC +12V 0.14 Amps. Is this the proper amperage level, or is it too low

>or too high?

The voltage rating is fine, the amerage level should be fine as well

as long as it's not too high where it overloads the powersupply (I doubt

that in this case). I've connected all sorts of fans to the "Fan" pins,

back when I was trying to cool down my accelerator board. I had a 486

CPU mini-cooling fan in there (0.9W) as well as a full-sized fan pulled

from an IBM powersupply, which had a higher power consumption rating.

They were all DC +12V in case your wondering, it was just the wattage/

amperage levels that differed.

You just need to slice the wires and stick them in a two-pin molex

connector, I found one on a dead 80 columns card. :)

Mitchell Spector

[email protected]

###################################################### E N D O F F I L E

Apple II Computer Technical Information : Apple II Family Hardware Info

ftp://ground.ecn.uiowa.edu/2/apple2/miscinfo/hardware : May 2001 : 185 of 572

1 2 ... 180 181 182 183 184 185 186 187 188 189 190 ... 571 572

Caple C871i Bedienungsanleitung Seite 185

Kommentare zu diesen Handbüchern

Caple C871i Bedienungsanleitung Seite 185

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Kochfelder Caple C871i